DentGist NanoCom Flowable Composite Shade - A2

Features
Ease of use 
Easy adaptation to cavity preparation
Does not stick to the composite filling instruments
Exceptional radiopacity
Flowable consistency
Excellent color stability
Durable restorations and maintain a gloss shine for long time
It can be polished to a high gloss finish ensuring optimum esthetics

Description
DentGist NanoCom Flow is an excellent flowable composite that delivers high strength & wear resistance. It is Characterized by optimum surface affinity and penetrates easily into most difficult areas. It combines esthetics as well as flow on demand handling for use.
Indications:
DentGist NanoCom Flow is indicated for direct filling of class V (Cervical Caries), root erosions, wedge shaped defects, fillings of anterior teeth (Class III & IV), small fillings in posterior teeth, repair of composite and ceramic veneers, block out of undercuts, adhesive cementing of composite and ceramic restorations.

Key Specifications
Composition :

Bisphenol A Glycidyl Methacrylate
Ethoxlated Bisphenol A Dimethacrylate
Urethane Dimethacrylate
Triethylene Glycol Dimethacrylate
Silanated Barium Glass Powder
Amorphous Fumed Silica

Storage :

Store at a temperature between 10 C to 24 C. Close the cap carefully after use. Keep away from moisture.

Packaging

1 x 2g Syringe
Direction to Use

Isolation : Rubber dam is the preferred method of isolation
Cavity preparation : Prepare cavity with minimal tooth reduction. Bevel cavo surface enamel margins
Apply Etchant Gel to enamel and dentin surfaces for 15 seconds. Rinse thoroughly for 15 seconds with water
Dry with clean, oil-free, air without desiccating the dentin
Do not allow etched surface to become contaminated with saliva or blood during the bonding procedure
Adhesive : Immediately after blotting, apply 2-3 consecutive coats of adhesive to etched enamel and dentin for 15 seconds with gentle agitation using a fully saturated applicator. Remove excess solvent by gently drying with dry air for at least 5 sec to ensure uniform glossy surface. Light cure for 20-30 seconds
Apply the material with applicator tip directly in the cavity and pre contour with a suitable instrument.
The layer should not be thicker than 2mm.
Light cure for 40 sec using standard curing light