Unident Dental Mechanical / Flask Press

Features
Built for use with 2 (two) muffles.
Pressure gauge.
Full control at different stages of pressing.
Required to work in laboratories, since the operator can control the pressure in the muffle.
Little effort is required.
It does not risk the operator.
It provides dimensional stability of the prosthesis.
The press does not require any special installation and initial processing before the operation.
Install on a flatlevel surface, so that it is stable to work, ensuring the proper height for handling.

Description
Dental Mechanical / Flask Pressis used in dental prosthodontic laboratories to load acrylic pressure packs for complete dentures and partials denture. The unit's self-contained hydraulics allow up to 3500 pounds of force with minimal physical effort by means of a hand lever.


Indications

The is used to press flaskto remove air bubbles.


ADVANTAGE:

strong
Easy handle
Simple

Key Specifications



Weight
9.7 kg


Operation mode
Manual


Material
Metal


Usage/ Application
Unident



Packaging
1 x Dental Mechanical / Flask Press

Direction of use
Step 1: 

Prepare the flask for pressing.


Step 2: 

Place the flask on the flat surface.


Step 3: 

Turn the center spindle for the right to play the flask flange.
Note: To reach the limit, exert a slight force on the muffle.


Step 4: 

Make sure the release valve is closed by turning the lower lever to the right.
Then do the pressuretest, moving the hydraulic lever up and down up to 0.5 tons,To drain excess resin.
When finishing the flow of excess resin, it will be the ideal choice for the final pressing.


Step 5: 

Make the final pressing, slowly, moving the hydraulic lever up and down for up to 1.0 ton.
As thepressing force The person was decreasing due to the stabilization of the resin inside the muffle (s), move the
hydraulic lever up and down to stabilize the pressure at 1.0 tons.


Step 6: 

After the time necessary to work, turn the side lever clockwise to loosen the release valve down to 0
ton, then turn the center spindle left to free the muffle.

Warranty

Manufacturer/Importer warranty of 1 Year against manufacturing defect
Service andWarrantyare handled by the manufacturer/importer directly for this product

Divne Medicare will not be liable to replace the Products and the liability to replace any such Product is that of the Manufacturer/Importer
Divne Medicare and the Buyer acknowledge that the Products purchased/used are a subject matter of original Manufacturer/Importerwarrantiesonly
Any or all claims in relation to returns and replacement shall be made to the concerned Manufacturer/Importer only and Divne Medicare may assist the customer in registering a request to get the Product replaced or serviced.
The Buyer acknowledges that the Products once sold will not be exchanged or taken back unless the seal of the package or the Product is intact or not altered in any manner or is not tampered as the case may be.