Voco Calcimol Lc Light - Cure

Features
Time-saving direct application and light-curing
Ready-to-use one-component material
Effective protection of the pulp
Acid-resistant
Supports the formation of secondary dentine

Description


Calcimol LC:
Light-curing radiopaque calcium hydroxide paste


Calcimol LC in the new NDT-syringe


NDTmeans non-dripping-technology
Especially for fine-flowing materials
Can be dosed and applied precisely
Without any loss of material

Indications


Indirect pulp capping
Lining under all filling materials
Protection when applying the total-etch technique

Precautions:


Do not useCalcimol LC in the restoration margins. In the marginal area, the permanent restoration should always be placed on caries-free dental hard tissue which, when using the adhesive technique, must have been conditioned accordingly.
Calcimol LCadheres to methacrylate-based products, e.g. crown and bridge materials, temporary sealing materials and certain impression materials (e.g. polyether), which can lead to removal of the cavity lining. In such cases, application of a separating agent is recommended (e.g. Vaseline, glycerine gel etc.). Remove the insulating material prior to placement of the final restoration.


Key Specifications

Store at temperatures of 4 ?C to 23 ?C protected from light and moisture.

Packaging
2 x 2.5gSyringes
Application cannulae type 41

Direction of use

Calcimol LC can be applied directly from the syringe.To ensure functioning of the non-dripping syringe, the plunger must not be retracted during or after use. Dispense the required amount of Calcimol LC from the tube onto a mixing pad and apply using a suitable instrument.
Cavity linings with a thickness in excess of 1 mm need to be built up in layers and each layer cured using blue light for at least 20 s. If increased adhesion values are required (e.g. when using Calcimol LC for adhesive restorative treatments), a suitable adhesive can be used prior to the application ofCalcimol LC.
Carefully remove any excess material prior to light-curing using suitable tools.
Do not remove polymerised excess material with a probe but, instead, carefully use a rotating instrument and then place the restoration.